Measuring Thermoprobe Flashlights Samplers Gas detection Batteries

 

Enforcer Calibration Accessory
 

The Enforcer provides easy and cost-effective 'bump testing' for the Impact range of multi gas detectors.

Regulations require regular testing of gas monitoring equipment to ensure that the instrument will work as and when required.

The Enforcer allows you to easily comply with regulations when using an Impact multi-gas monitor without the need for costly test facilities or third parties.

‘Bump’ testing should be carried out before use of any portable gas detector. This involves exposing each gas sensor to a known concentration of target gas and ensuring that it responds correctly. If not, the unit must be re-calibrated or serviced to replace those parts not working.

Personal gas monitors are normally calibrated every 3 to 6 months. Typically this requires specialist knowledge and equipment that is costly or the work is sub-contracted to a third party. During this time instruments are not available for use and so could delay essential operations or force additional monitors to be purchased.

The Enforcer calibrates Impact multi-gas monitors fitted with Oxygen, flammable, Carbon Monoxide and Hydrogen Sulphide sensors in less than two minutes. Volumes and flow rates are minimised to allow approximately 200 calibrations per cylinder of gas making calibration as low in cost as a ‘Bump’ test.

Impact instruments when used with the Enforcer are always available for use. Calibration results are recorded for printing at a later date via the optional PC software thereby ensuring that instrument histories are always available if required.

______________________________________________________________________
Downloads:

Datasheet Enforcer



 


  
 

Hartwig instruments
Pottebakkerstraat 15
NL3194AD Rotterdam-Hoogvliet
Tel: +31(0)10-438-5286
Fax: +31(0)10-438-2099
E-mail: info@hartwig.nl
 
Sitemap Inloggen